Avigilon Rialto R Series Analysis Device Quick Start Guide

About this manual

The document provides instructions for installing the Rialto analysis device in a rack. It details how to install the module using screws and slide it into an empty slot on the back of the unit.

The guide explains initial setup steps, including downloading Avigilon View software and connecting the device to a network. It covers establishing connections via DHCP or manual IP assignment using the Discovery Tool. This manual is written in Chinese.

What's inside

• Installation
• Initial Setup
• Network Connection
• Connecting Cameras
• IP Camera Requirements

Frequently asked questions

What tool is required to remove the screws on the back of the Rialto R Series analysis device?

You must use a No. 1 Phillips screwdriver to remove the four screws on the empty panel.

How long should you wait for the device to power up and be ready?

You should wait approximately 5 minutes for the device to power up and be ready.

What are the supported video resolutions for IP cameras connected to the Rialto R Series?

The device supports 1920 x 1080 (1080 p), 1280 x 1024, 1280 x 720 (720 p), or any resolution of 800 x 600 or lower.