User manual for Audio-Technica BP28/BP28L line + gradient large-diaphragm condenser microphones, covering connection, switch settings, and specifications.
User manual for the Audio-Technica BP28 and BP28L back-electret condenser line + gradient shotgun microphones. It covers features, safety precautions, notes on use, connection to a phantom-power-compatible balanced microphone input, low-cut and pad switch settings, and technical data.
The document lists different lengths for the two models: BP28 is 354.9 mm long and BP28L is 567.9 mm long. It also states a transformer-coupled output, an 80 Hz low-cut filter, a 10 dB pad, an XLR-M output connector, and included accessories. This manual is written in Japanese.
| Element | Fixed-charge back plate, permanently polarized condenser |
|---|---|
| Polar pattern | Line + gradient |
| Frequency response | BP28: 20-19,000 Hz; BP28L: 20-20,000 Hz |
| Low cut | 80 Hz, 18 dB/octave |
| Pad | -10 dB |
| Open circuit sensitivity | BP28: -28 dB (39.8 mV); BP28L: -23 dB (70.8 mV) at 0 dB=1 V/Pa, 1 kHz |
| Impedance | 250 ohms |
| Maximum input sound level | BP28: 143 dB SPL (1 kHz at 1% THD), 153 dB SPL with pad on; BP28L: 138 dB SPL (1 kHz at 1% THD), 148 dB SPL with pad on |
| Noise | BP28: 8 dB SPL (A-weighted); BP28L: 3 dB SPL (A-weighted) |
| Dynamic range | 135 dB (1 kHz at Max SPL) |
| Signal-to-noise ratio | BP28: 86 dB (1 kHz at 1 Pa, A-weighted); BP28L: 91 dB (1 kHz at 1 Pa, A-weighted) |
| Phantom power requirements | 11-52 V DC, 3.4 mA |
| Switches | Low cut: on/off; Pad: on/off |
| Weight | BP28: 223 g (7.9 oz); BP28L: 313 g (11 oz) |
| Dimensions | BP28: 354.9 mm long; BP28L: 567.9 mm long; 28.0 mm maximum body diameter |
| Output connector | Integral 3-pin XLR-M type |
| Included accessories | Windscreen (BP28: AT8170 / BP28L: AT8169), holder (AT8470), stand adapter (3/8”-5/8”), carry case |
The BP28 is 354.9 mm long and the BP28L is 567.9 mm long.
It has an integral 3-pin XLR-M output connector.
Turn on the low-cut filter switch located on the side of the product.
Set the pad switch to -10 dB if the audio input exceeds the maximum input sound level.