AiM EMU Classic/EMU Black ECU User Guide

AiM user guide for connecting EcuMaster EMU Classic and EMU Black ECUs via CAN, covering software setup, wiring, and Race Studio configuration.


AiM EMU Classic/EMU Black ECU User Guide - cover page
Brand
Aim
Category
Car parts
Document type
User Manual
Language
English
Pages
6
File format
PDF
File size
727 KB
Published
16 November, 2026
Updated
16 November, 2026
MD5 checksum
2CB6CAFD3AB70DD3A63445D62DE3CAD7

About this manual

This AiM user guide explains how to connect EcuMaster EMU Classic and EMU Black ECUs to AiM devices using CAN communication. It covers supported models, software setup, wiring connections, and Race Studio 3 configuration.

The document lists CAN bus settings, connector pinouts for both ECUs, notes on the 120 Ohm termination resistor, and the channels received by AiM devices under the ECU MASTER – EMU / EMU 1 protocol.

What's inside

  • Supported models
  • Software setup
  • Wiring connection
  • EMU Classic
  • EMU Black
  • Race Studio configuration

Specifications

CAN Bus Speed500 Kbit/sec
Base ID (EMU Black)600
CAN termination resistor120 Ohm
ECU manufacturerECU MASTER
ECU ModelEMU 500K bit/sec / EMU 1MB 1Mbit/sec (Only RS3)

Frequently asked questions

What CAN bus speed is required?

The required CAN bus speed is 500 Kbit/sec.

Which ECU models are supported?

The supported models are Ecu Master EMU Classic (CAN) and Ecu Master EMU Black (CAN).

Which software is used for ECU configuration?

Use AiM Race Studio 3 software to set up the ECU before connecting it to an AiM device.

Which channels work only with EMU Black?

ECU ANAL5, ECU ANAL6, and ECU OutFlags 1 through 4 work only with an EMU Black ECU.

Download PDF (727 KB)

More Aim Manuals


View all Aim manuals →