IBM QRadar Network Packet Capture V7.3.1 Installation Guide

This document describes how to install and configure IBM QRadar Network Packet Capture.


IBM QRadar Network Packet Capture V7.3.1 Installation Guide - cover page
Brand
IBM
Category
Security Software
Document type
Installation Guide
Language
English
Pages
29
File format
PDF
File size
949 KB
Published
30 November, 2023
Updated
30 November, 2023
MD5 checksum
3ED25482F066A50D6E4A244AB05EA05C

About this manual

This guide provides information to install and configure IBM QRadar Network Packet Capture V7.3.1. It applies to IBM QRadar Security Intelligence Platform V7.3.1 and subsequent releases unless superseded by an updated version.

It covers installation on IBM supplied appliances and custom appliances, upgrading, configuring IP address and network settings, and verifying the capture port, time synchronization, and external LEDs.

What's inside

  • Introduction to installing QRadar Network Packet Capture
  • Installation overview
  • Installations on IBM supplied appliances
  • QRadar Network Packet Capture hardware
  • Configuring IP address and network settings
  • Installations on custom appliances
  • Minimum requirements for custom installations
  • Verify the QRadar Network Packet Capture installation

Specifications

Front panel identifierIBM QRadar PCAP G3
Installed network hardwareIntel X520 Ethernet adapter and Napatech NT40E3-4-PTP accelerator
Packet capture adapterNapatech card only
Management adapterIntel X520 for management purposes only
Capture sourcesUp to four capture port sources
Port speedDual-rate 10G/1G ports
Supported SFP modulesSFP+ 10GBASE-SR, SFP+ 10GBASE-RR, SFP 1000BASE-SX, SFP 1000BASE-LX, SFP 1000BASE-T
Capture and analysisFull packet capture and analysis with zero packet loss

Frequently asked questions

What does the IBM QRadar Network Packet Capture V7.3.1 installation guide cover?

It provides information needed to install and configure IBM QRadar Network Packet Capture.

Which releases does the guide apply to?

It applies to IBM QRadar Security Intelligence Platform V7.3.1 and subsequent releases unless superseded by an updated version.

Can you upgrade directly to QRadar Network Packet Capture V7.3.1 from earlier versions?

Yes. You can upgrade directly to QRadar Network Packet Capture V7.3.1 from earlier versions.

Which card is used for packet capture on the IBM appliance?

Use only the Napatech card for packet capture. The Intel X520 is for management purposes only.

Download PDF (949 KB)

More IBM Manuals


View all IBM manuals →