The Dell™ PowerVault™ MD1220 Storage Enclosures Getting Started With Your System Guide introduces the features and characteristics of the product.
Dell PowerVault MD1220 is a storage enclosure that supports up to 24 2.5-inch SAS hot-swappable hard drives. This guide covers unpacking, rack installation, power connection, startup, optional bezel installation, and technical specifications.
It also describes unified and split mode connectivity, RAID controller and management software support, backplane and EMM connectors, LED indicators, power supply ratings, and per-slot power limits.
| Drives | Up to 24 2.5-inch SAS hot-swappable hard drives |
|---|---|
| Enclosure Management Modules | One or two hot-swappable modules with temperature sensors and an audio alarm |
| Unified mode | Direct connectivity to 24 hard drives per enclosure |
| Daisy-chained enclosures | Up to four daisy-chained storage enclosures |
| Drives per controller port | 96 hard drives per controller port |
| Drives per controller | 192 hard drives per controller |
| Controllers per server | Maximum of two dual port controllers per server |
| Maximum drives per server | 384 drives |
| Redundant path connectivity | Provides redundant data paths to each hard drive |
| Split mode drive connectivity | Direct connectivity to drives 0 through 11 and 12 to 23 |
| Split mode limitations | Does not support daisy-chaining or redundant data paths |
| RAID controller | PowerEdge RAID controller H800 |
| RAID management | Dell OpenManage Server Administrator 6.2 or later |
| Backplane SAS hard-drive connectors | 24 |
| Backplane power supply/cooling fan module connectors | Two |
| Backplane EMM connectors | Two sets |
| Backplane control panel connector | One connector for front LEDs and enclosure mode switch |
| Temperature sensors | Two |
| SAS IN connector per EMM | One connector for connection to the host |
| SAS OUT connector per EMM | One connector for expansion to an additional enclosure |
| SAS connector compliance | SFF-8086/SFF-8088 compliant |
| Serial connector per EMM | One 6-pin UART mini-DIN connector |
| Serial connector use | For engineering use only |
| Front panel system status LED | One two-color LED indicator |
| Front panel power and split mode LEDs | Two single-color LED indicators |
| Hard-drive carrier activity LED | One single-color LED |
| Hard-drive carrier status LED | One two-color LED per drive |
| EMM status LEDs | Three two-color LED status indicators |
| Power supply/cooling fan LEDs | Three LED status indicators |
| System identification button | Located on the front control panel |
| Mode switch | Located on the front control panel |
| Power supply wattage | 600 W |
| Power supply voltage | 100-240 VAC (8.6 A-4.3 A) |
| Power supply heat dissipation | 188 W |
| Power supply maximum inrush current | May reach 55 A per power supply for 10 ms or less |
| Hard drive power per slot at +5 V | Up to 1.2 A |
| Hard drive power per slot at +12 V | Up to 0.5 A |
| EMM power consumed | 14 W at +12 V |
| EMM maximum available power at +12 V | 100 W |
| EMM maximum available power at +5 V standby | 1 W |
| NOM supply voltage | 100-240 V CA |
| NOM frequency | 50/60 Hz |
| NOM current consumption | 8.6 A |
It supports up to 24 2.5-inch SAS hot-swappable hard drives.
It supports host-based RAID using the PowerEdge RAID controller H800.
RAID management uses Dell OpenManage Server Administrator 6.2 or later.
It switches the system between unified and split mode operation.