The Dell PowerConnect W-Series W-AP134 and W-AP135 Instant access points support the IEEE 802.11n standard for high-performance WLAN. These access points use MIMO (Multiple-in, Multiple-out) technology and support existing 802.11a/b/g/n wireless services.
This installation guide covers the Dell PowerConnect W-IAP130 Series Instant Access Point, including the W-AP134 and W-AP135 models. It describes the access point hardware, including LEDs, antenna connectors, console and Ethernet ports, power options, and security slot, and lists pre-installation requirements and a five-task setup process.
Installation topics include identifying locations, mounting with the included ceiling rail adapters, connecting Ethernet and console cables, powering the unit, and verifying post-installation connectivity using the LED indicators. The guide also provides Ethernet and console port pin-outs and instructions for resetting the access point to factory defaults.
| Wireless standard | IEEE 802.11a/b/g/n |
|---|---|
| MIMO | Multiple-in, Multiple-out |
| Ethernet ports | 2 x 10/100/1000Base-T RJ-45 |
| Power over Ethernet | IEEE 802.3at, 56 VDC |
| DC power | 12 V DC |
| Ethernet cable | Category 5 UTP, up to 100 m (325 ft) |
| LEDs | 5 |
| Antennas (W-AP134) | External |
| Antennas (W-AP135) | Internal |
| Security | Kensington security slot |
| Included mounting adapters | 9/16 in and 15/16 in ceiling rail adapters |
| Minimum software | Dell PowerConnect W-Instant 6.1.2.3-2.0.0.0 or later |
It requires Dell PowerConnect W-Instant 6.1.2.3-2.0.0.0 or later.
Use the ENET 0 port for uplink connections to a switch or router.
No, the ENET 1 port does not provide wired connectivity.
Power off the unit, press and hold the reset button, power it on without releasing the button, then release it after the power LED flashes.