The Dell Precision 360 Service Manual provides information on how to remove and replace Dell Precision Workstation 360 components.
This service manual provides procedures for removing and replacing components, assemblies, and subassemblies in the Dell Precision 360 computer. It covers mini-tower and desktop configurations, recommended tools, precautionary measures, and protection against electrostatic discharge.
The manual also documents the system board components, cable colors, jumper settings, front panel removal and replacement, and power supply removal and replacement.
| Full-length PCI card slots | 1, 3, and 4 |
|---|---|
| 64-bit PCI card slots | 2, 3, and 4 |
| Password jumper default | Password features enabled |
| Clear CMOS jumper default | Normal CMOS function |
A small flat-blade screwdriver, #1 and #2 Phillips-head screwdrivers, and possibly an 8-inch #2 Phillips-head screwdriver.
Discharge static electricity by touching an unpainted metal surface on the computer chassis before touching electronic components.
Wait 5 seconds, or until the standby light is extinguished, after turning off the computer and unplugging the power cable.
Release the eight tabs on each panel, then release the three front-bezel tabs and remove the control panel screw.