Eastman Tritan™ copolyester provides customers excellent toughness as well as clarity, chemical resistance, dimensional stability, low and stable shrinkage rates, and other enhanced physical properties. Versions of Tritan are also available with various additive packages, such as UV and color. To optimize these physical properties and widen the processing window, some drying and processing guidelines are listed.
Eastman Tritan copolyester offers excellent toughness, clarity, chemical resistance, and dimensional stability. This document outlines specific drying and processing guidelines to optimize these properties and widen the processing window. It covers drying parameters, moisture content targets, and equipment setup requirements.
| Target pellet moisture | 0.01% to 0.02% (100–200 ppm) |
|---|---|
| Dryer capacity minimum | 8,000 lb for 1,000 lb/hr production |
| Minimum airflow | 1 CFM per lb/hr extrusion rate |
| Minimum dew point temperature | 220°F (pref. 240°F) |
| Screw L/D ratio | 32:1 |
| Typical screw speed | 100 rpm |
| Typical melt pump speed | 60 rpm |
| Melt temp. max. | 450°F (280°C) |
| Maximum regrind level | 25% |
Dry Tritan at 180°F for 6–8 hours using a desiccant dryer.
The moisture content should ideally be less than 100 ppm, though up to 200 ppm may yield acceptable quality.
Do not dry over 20 hours to prevent excessive molecular weight loss and property decrease.
The maximum melt temperature is 450°F (280°C).