This document is the user manual and technical manual for Sailmaking Plotter. It introduces the features and characteristics of the product.
This document combines a user manual and a technical manual for a sailmaking plotter. The user part explains that the plotter is controlled by a PC running the Microsoft DOS operating system and a sailmaking application called ProSail; when the PC is turned on, DOS boots and a menu application starts automatically, from which the user may enter DOS (select "8") or enter ProSail.
The technical part describes the plotter as an open-loop control system made up of a PC, a desk of electronics and the plotter mechanical system: D/A converter cards in the PC drive power amplifiers in the desk, which drive the X and Y axis motors whose position encoders feed back through a handmade decoder PCB to digital input cards in the PC, while a third Z axis motor rotates the sailcloth. It also covers the console with lamps and switches, the microswitch interlocks and emergency stop, the deliberate isolation of the PC from the network, and the PC card layout with the base addresses of the game port, PCL-720 digital I/O and PCL-726 D/A cards. Much of the document consists of figure captions, and several sections are still marked as placeholders to be written.
| PC operating system | Microsoft DOS |
|---|---|
| Game port card base address | 0200H |
| PCL-720 digital I/O card base address | 02A0H |
| PCL-726 D/A card base address | 0300H |
| Number of controlled axes | X, Y and Z |
It runs the Microsoft DOS operating system, chosen because the ProSail application was designed for that DOS version.
A menu application starts automatically at boot; from it the user may enter DOS (select "8") or enter ProSail.
The X axis is vertical, along the roll of sailcloth, and the Y axis is horizontal.
Microswitch interlocks disable the motors, but they do not brake them, so inertia may still cause the arm to hit the spring-loaded end-stops.