Nokia IP290 Intrusion Prevention with Sourcefire Getting Started Guide
The Nokia IP290 Intrusion Prevention with Sourcefire, also called the Nokia IP290 IPS, is a network security appliance designed for the Sourcefire 3D Sensor application. It runs the hardened Nokia IPSO-LX operating system and comes with Sourcefire Intrusion Prevention System (IPS) and Real-time Network Awareness (RNA) preinstalled; both can run at the same time. This Japanese getting started guide carries part number N450000523 Rev 001 and was published in May 2007.
The guide describes the front and rear panel components, including the built-in 10/100/1000 Ethernet ports, the console and AUX ports, the PMC expansion slot and the status LEDs. It then covers installing the unit in a rack with or without the shell, connecting the console port and management interface, connecting power and switching on, and performing initial configuration with Nokia Network Voyager or the command line interface. Later sections cover Gigabit Ethernet network interface card connections, replacing components, technical specifications and compliance information. This manual is written in Japanese.
| Height | 1.7 in. (4.3 cm) in the shell |
|---|---|
| Width | 8.5 in. (21.7 cm) |
| Depth | 19.0 in. (48.3 cm) including front handles |
| Weight | 9.1 lbs. (4.1 kg) for one base system with mounting brackets |
| Maximum operating altitude | 3300 m (10,000 ft) above sea level |
| Operating temperature range | 41 to 104°F (5 to 40°C) |
| Input voltage | 115 VAC or 220 VAC, 50 or 60 Hz |
Sourcefire Intrusion Prevention System (IPS) and Real-time Network Awareness (RNA) are preinstalled, and both can run at the same time.
It runs Nokia IPSO-LX, described in the guide as a hardened operating system.
Two units can be mounted in a 1U rack space when installed in the rack-mountable shell.
No. The guide notes that IPSO-LX 7.1 does not support use of the AUX port.