Electrolube Ultraclens ULC Solvent Technical Data Sheet

ULC is a special blend of solvents for cleaning of critical electro-mechanical applications, and is highly recommended for cold cleaning applications in conjunction with all types of electro-mechanical equipment.


Electrolube Ultraclens ULC Solvent Technical Data Sheet - cover page
Brand
ELECTROLUBE
Category
Chemical products
Document type
Datasheet
Language
English
Pages
2
File format
PDF
File size
35 KB
Published
02 November, 2023
Updated
02 November, 2023
MD5 checksum
1DA31B0340467A9CDADB5CDAB21267C5

About this manual

This is Electrolube's technical data sheet for ULC, also referred to in the document as Ultraclens, a special blend of solvents for cleaning critical electro-mechanical applications. It describes the product as highly recommended for cold cleaning in conjunction with all types of electro-mechanical equipment, and as suitable for cleaning tanks because of its low evaporation rate and high flashpoint. It is intended for rapid cleaning where water-based chemicals are inadvisable, removing grease, oxides, flux and general dirt.

The sheet lists product features and physical properties including form, boiling point, freezing point, vapour pressure, specific gravity, viscosity, inhalation toxicity and flash point, and notes that the product should be tested on a small area before use on plastics. A second page gives residue on evaporation and the packaging order codes for aerosol and bulk sizes.

What's inside

  • Product Description
  • Product Use
  • Features
  • Properties
  • Residue on Evaporation
  • Packaging Order Code

Specifications

FormClear, colourless liquid
Boiling Point173-193°C
Freezing Point<-50°C
Vapour Pressure @ 38°C3.75 mm/Hg (0.5 kPa)
Specific Gravity @ 20°C0.79
Viscosity @ 20°C1.48
Flash Point>60°C
Inhalation Toxicity300 ppm
Residue on Evaporation<10 ppm

Frequently asked questions

What is Electrolube ULC used for?

It is used for safe, rapid cleaning of all types of electro-mechanical equipment where water-based chemicals are inadvisable, removing grease, oxides, flux and general dirt.

What pack sizes and order codes are available for ULC?

A 200 ml aerosol (ULC200D), 400 ml aerosol (ULC400D), 1 litre bulk (ULC01L), 5 litre bulk (ULC05L) and 25 litre bulk (ULC25L).

Can ULC be used on plastics?

It is stated to be safe on most plastics, but a small area should be tested before use.

What is the flash point of ULC?

The flash point is greater than 60°C.

Download PDF (35 KB)

More ELECTROLUBE Manuals


View all ELECTROLUBE manuals →