NHR-M35 series switch value converter is a product that can receive switch value signal and convert it to isolated switch value signal output, input signal can be touch switch or proximity switch, output signal can be relay output or transistor output, input and output can be reversed control, the product needs independent power supply, input/output/power three isolation.
Hong Run NHR-M35 series switch quantity converter converts incoming switch signals into isolated switch outputs for external control or alarm use. It provides input status indication, supports in-phase or reverse-phase control, and has input, output, and power three-way isolation; it requires independent power and mounts on a 35 mm DIN rail.
The manual covers panel layout, selection table, technical parameters, wiring diagrams, and DIP switch J5 settings. Specifications include relay or transistor outputs, DC 24 V or AC 100-265 V power, insulation and EMC requirements, and operating conditions. This manual is written in Chinese.
| Input signal | Contact switch, proximity switch (frequency ≤5 kHz) |
|---|---|
| Output signal | Relay or transistor output |
| Relay output capacity | AC 220 V/10 A, DC 30 V/2 A |
| Collector output voltage | High level VCC (≤30 V), low level ≤2.5 V |
| Emitter output voltage | High level VCC-2.5 V, low level ≤0.5 V |
| Power supply | DC 24 V (±10%), AC 100-265 V 50/60 Hz |
| DC power consumption | Single output ≤0.8 W; dual output ≤1.2 W |
| AC power consumption | Single output ≤1.0 W; dual output ≤1.4 W |
| Insulation resistance | ≥100 MΩ (at 500 VDC) |
| Dielectric strength | 1500 Vrms (1 min, no spark) |
| Operating temperature | 0 to 50 °C (no condensation or icing) |
| Relative humidity | 25% to 85% RH |
| Storage temperature | -10 to 60 °C (no condensation or icing) |
| Mounting | 35 mm DIN rail |
| Dimensions | 18.5 x 109 x 116.5 mm (W x H x D) |
| Electromagnetic compatibility | Conforms to GB/T18268 industrial equipment application requirements (IEC 61326-1) |
EVT1/EVT2 are green when the input signal is shorted and red when it is open.
Set switch 1 to ON and switch 2 to OFF for in-phase control; the reverse setting gives reverse-phase control.
Set switch 3 to ON and switch 4 to OFF for in-phase control; the reverse setting gives reverse-phase control.
It supports DC 24 V (±10%) or AC 100-265 V at 50/60 Hz.