This is a repair manual for Hobart 2912SC automatic slicer
This service manual supplement from Hobart Corporation covers the model 2912SC automatic slicer, ML-104832, which displays a slice count with six user-programmable preset values. It is prepared for trained Hobart service technicians and is meant to be used together with 2000 Series Service Manual Form 24569 (02-98). The operation section refers to the 2912SC Instructions Manual F-34213 (2/99).
The supplement gives removal and replacement procedures for the slice count keypad and bezel, the slice switch (3LS), the slicer control board and the motor control board. It also covers testing the motor control board and automatic drive motor, the automatic low/high speed adjustment, electrical operation with a component function list and sequence of operation, a wiring diagram, and troubleshooting. Specified tools include Loctite No. 242 and trimpot tool 539123.
| Model | 2912SC (Automatic) Slice Count Slicer |
|---|---|
| ML number | ML-104832 |
| Preset slice count values | Six |
| Motor continuity range | 4 to 8 ohms |
| Low speed setting | 16 ± 2 strokes per minute |
| High speed setting | 50 ± 2 strokes per minute |
| Motor crank link bolt torque | 90 inch pounds |
| Automatic motor mounting screw torque | 25 ± 3 inch pounds |
| Electrical supply example | 120/60/1 |
Loctite Number 242 (part number 520228) is used on automatic motor mounting screws, and trimpot tool part number 539123 is used for adjusting the automatic low/high speeds.
Six preset values can be user programmed for the slice count.
The normal range is 4 to 8 ohms when continuity checking the motor and motor wiring including the brushes.
Adjust the low speed potentiometer until 16 ± 2 is displayed, and the high speed potentiometer until 50 ± 2 is displayed.