M100 Stopswitch is a motion monitor produced by 4B company.
This manual provides installation and operation instructions for the 4B M1001V10F Stopswitch, a shaft speed monitoring device that signals when rotation stops. It includes safety guidelines, wiring diagrams, testing procedures, and troubleshooting steps. The device requires no calibration and operates with a 24–240V AC/DC supply, featuring a 4-second startup delay and IP67 protection. Installation must comply with local electrical codes and include a guard for rotating parts.
The manual emphasizes customer safety responsibilities, including proper installation by qualified electricians, regular maintenance, and adherence to OSHA and local codes. It also details wiring configurations, sensor target distances, and LED indicators for input and output states.
| Supply Voltage | 24 to 240 Volts AC/DC |
|---|---|
| Switching Capacity | 200 mA |
| Operating Temperature | -13°F (-25°C) to +158°F (+70°C) |
| Sensing Range (Ferrous) | 5/16 in. (8 mm) maximum |
| Enclosure | Nylon - ISO Threaded 18 mm by 1 mm Pitch |
| Output State | Normally Closed (Volt Drop 8 Volts Max.) Above Minimum Input Speed, Normally Open (Leakage Current 1.6 mA Max.) at Stopped Motion |
| Start Up Delay | 4 Seconds |
| Protection Rating | IP67 |
Maximum 5/16 in. (8 mm) for ferrous targets, assuming a 3/4 in. (19 mm) diameter target.
The output becomes normally open (green LED off) if no input is received for 4 seconds.
24 to 240 Volts AC/DC.
Yes, OSHA requires a full guard for exposed rotating shafts; the device and target must be equipped with one.