Hitachi WL200 Series Inverter EMC Installation Guide

This manual provides recommendations on how to install the Hitachi WL200 series inverters to achieve electromagnetic compatibility (EMC).


Hitachi WL200 Series Inverter EMC Installation Guide - cover page
Brand
Hitachi
Category
inverter
Document type
Installation Guide
Language
English
Pages
20
File format
PDF
File size
750 KB
Published
19 October, 2023
Updated
19 October, 2023
MD5 checksum
74389F93BC0B8AEA6261D861331DD9E3

About this manual

This guide provides instructions for installing Hitachi WL200 series inverters to meet electromagnetic compatibility (EMC) standards. It covers selecting appropriate line filters based on inverter model and voltage, installing filters and motor cables, minimizing radiated interference, and proper shielding and grounding techniques. The guide also addresses motor cable length limits and compatibility with ground fault monitoring devices.

Key safety warnings include keeping motor cables under 50m, using AC reactors for longer cables, and ensuring proper grounding to avoid electric shock. The document specifies filter models for different inverter variants and outlines EMC compliance with EN 61800-3 standards.

What's inside

  • Warnings and Instructions
  • Electromagnetically Compatible Installation of Drives and Drive Systems
  • Influence of Motor Cable Length
  • Further Notes
  • Technical Specifications and Dimensions of WL200 Filter
  • Harmonics

Specifications

EMC Compliance StandardEN 61800-3

Frequently asked questions

What EMC standard does this guide follow?

The guide follows EN 61800-3 for emissions and immunity standards.

What is the maximum recommended length for the motor cable?

The motor cable length should not exceed 50m to avoid increased capacitive current and electromagnetic emission.

How long must one wait after switching off the line voltage before touching terminals?

You must wait a minimum of 60 seconds before removing protective covers or touching terminals to avoid electric shock.

What is the minimum cross-section required for the grounding conductor connecting the filter to the drive?

The grounding conductor must have a cross-section of at least 10mm2 to ensure a solid and permanent connection.

Download PDF (750 KB)

More Hitachi Manuals


View all Hitachi manuals →