The SF 51 and SF 54 control panels are designed for the FastMig series of welding machines and offer a modern set of control options, including digital and analog controls. The control panels provide a number of features that can help you improve productivity and achieve high-quality welding results.
This manual provides instructions for operating the Kemppi FastMig SF 51 and SF 54 control panels, including mounting, function panel controls, setup parameters, and troubleshooting. It details how to connect the panels to compatible power sources and adjust welding parameters such as wire feed speed, arc voltage, and gas flow. Safety warnings and setup procedures are emphasized to ensure proper use and prevent damage.
The panels support both MIG and MMA welding processes and can be configured for air- or water-cooled MIG guns. The manual includes step-by-step guidance for adjusting settings, using remote control, and handling error codes. Technical specifications are listed at the end for reference.
| Device Address | 3 or 6 |
|---|---|
| Gas Guard Connected | on/off |
| LongSystem Mode | on/off |
| Cable Length | std, 5–80m |
| Pre Gas Time | 0.0–9.9 s |
| Post Gas Time | 0.0–9.9 s |
| Creep Start Level | 10–170% |
| Start Power | -9 to +9 |
| Post Current Time | -9 to +9 |
| Arc Voltage | OFF/on |
These panels are compatible with FastMig KMS 300, 400, or 500 power sources.
Set the gas flow time between 0 and 60 seconds using the right potentiometer; the new setting is saved in memory.