Lippert Schwintek In-Wall Slideout System Troubleshooting Guide

About this manual

This troubleshooting guide is designed for the Lippert Schwintek In-Wall Slideout System to help diagnose and resolve common issues. It addresses scenarios where the system is inoperative or the room is stuck in either the extended or retracted position. The document outlines procedures for electronic manual overrides and disengaging motors to manually retract or extend the room.

What's inside

• System Inoperative
• Motors and Harnesses
• Room Stuck Out
• Room Stuck In
• Visual Inspections
• Measurements
• Floor Rollers
• V-Rollers
• Gear Racks

Specifications

Frequently asked questions

How do I enter electronic manual override mode?

Press the mode button six times quickly, then press and hold it for approximately five seconds until the red and green LED lights flash.

What happens if the wall switch is not pushed within 60 seconds of entering override mode?

The controller will revert to normal operating mode, and no action is required to return to it.

How do I manually retract the room if it is stuck out?

Disengage the motors by removing the motor retention screw, pulling the motor up until disengaged, and then pushing or pulling the room back in.