Lippert F.A.S.T. Track Slide-Out Service Manual

About this manual

This document is a service manual for the Lippert F.A.S.T. Track Slide-Out system, a cable-driven mechanism operated by a 12V DC electric motor. The system is designed to actuate rooms up to 2,000 lbs and 40 inches of stroke. It includes information on major components, safety procedures, and operation instructions for extending and retracting the room.

What's inside

• System Information
• Major Components
• Safety Information
• Prior to Operation
• Operation
• Programming
• Troubleshooting
• Fault Codes
• Service Instructions
• Motor Replacement

Specifications

Frequently asked questions

What is the minimum voltage required for the slide-out to move?

The room will not move if the voltage is 10.5V DC or below.

What should be done if the parking brake is not set?

Set the parking brake (if applicable) and check for continuity to ground on the wire plugged into the parking brake receptacle.

How do you set the retract stop point?

Press and hold the "IN" or "RET" button, move the room to the fully retracted position, and hold the button for 2 seconds after it stops.