AlliedTelesis x900 Series and SBx908 Switch Bay Provisioning Guide

This guide describes the operation of provisioning under AlliedWare Plus.


AlliedTelesis x900 Series and SBx908 Switch Bay Provisioning Guide - cover page
Brand
Allied Telesis
Document type
User Manual
Language
English
Pages
12
File format
PDF
File size
414 KB
Published
17 October, 2023
Updated
17 October, 2023
MD5 checksum
D234A20639EE3892CB57E036D50777DC

About this manual

This guide explains how to pre-configure interfaces on hardware not yet installed, enabling seamless hot-swapping later. It covers provisioning for XEM bays and chassis cards, board classes, applying and removing configurations, and managing changes. Provisioning is enabled by default and cannot be disabled. Configuration is retained only if saved before rebooting.

The guide also addresses compatibility issues: mismatched hardware types (e.g., inserting a non-POE switch into a POE-provisioned slot) will cause configuration failures. Version upgrades or downgrades affect provisioning commands — saving configurations with newer versions may cause errors on older software.

What's inside

  • Introduction
  • Products and software version that apply to this guide
  • x900 Series and SBx908: Switch Bay Provisioning for XEMs
  • Provisioned board Classes
  • Applying hardware provisioning
  • Removing or changing XEM bay provisioning
  • Displaying provisioned configurations
  • Provisioning and change management
  • Provisioning and software version aspects

Frequently asked questions

Can I disable provisioning?

No, provisioning is ON by default and cannot be disabled.

What happens if I save a configuration with a newer software version and then downgrade?

Error messages will result if the configuration has been saved using the newer version, because the provisioning commands will be unknown to the older software.

Download PDF (414 KB)

More Allied Telesis Manuals


View all Allied Telesis manuals →