Intersil ISL23710 Digitally Controlled Potentiometer Datasheet

The Intersil ISL23710 is a digitally controlled potentiometer (XDCP). The device consists of a resistor array, wiper switches, and a control section. The wiper position is controlled by a Up/Down interface. The potentiometer is implemented by a resistor array composed of 127 resistive elements and a wiper switching network. Between each element and at either end are tap points accessible to the wiper terminal. The position of the wiper element is controlled by the CS, U/D, and INC inputs. The wiper register is volatile and is reset to midscale on power up. The wiper position can be locked while powered up to prevent inadvertent changes. The device can be used as a three-terminal potentiometer or as a two-terminal variable resistor in a wide variety of applications including: Industrial and Automotive Control, Parameter and Bias Adjustments, Amplifier Bias and Control Features, Up/Down Interface with Chip Select Enable, DCP Terminal Voltage from ±2.7V to ±5V, 127 R


Intersil ISL23710 Digitally Controlled Potentiometer Datasheet - cover page
Brand
Intersil
Category
Other Electronics
Document type
Datasheet
Language
English
Pages
8
File format
PDF
File size
227 KB
Published
02 August, 2012
Updated
28 September, 2023
MD5 checksum
07C6E2FF122BB9D987BEEDE42C6C1E6E

About this manual

The Intersil ISL23710 is a digitally controlled potentiometer (XDCP) consisting of a resistor array, wiper switches, and a control section. The device features a 127-element resistor array with accessible tap points controlled by a CS, UID, and INC inputs. It operates as a three-terminal potentiometer or a two-terminal variable resistor.

What's inside

  • Features
  • Ordering Information
  • Pinout
  • Absolute Maximum Ratings
  • Recommended Operating Conditions
  • Analog Specifications
  • Operating Specifications
  • Serial Interface Specs

Specifications

Resistor Array Elements127
Terminal Voltage Range+2.7V to +5V
Available Resistance Options10kQ, 50kQ
Ratiometric Temperature Coefficient+4ppm/°C
End to End Resistance Range+20%
Wiper Resistance (Typical)70Q
Active Current (Max)1mA
Standby Current (Max)500nA
Package Type10 Ld MSOP

Frequently asked questions

What is the typical wiper resistance at 3.3V?

The typical wiper resistance is 70 ohms when the supply voltage is 3.3V.

What is the maximum active current of the device?

The maximum active current is 1mA.

Is the wiper position volatile?

Yes, the wiper register is volatile and is reset to midscale on power up.

Download PDF (227 KB)

More Intersil Manuals


View all Intersil manuals →