IFM E3D200 Programming Manual

About this manual

This manual describes the PC operating program for the IFM E3D200 sensor, covering safety instructions, system requirements, and detailed installation steps. It explains how to start the software from the CD, copy it to the hard disk, or install it permanently, and how to configure network settings for communication with the sensor.

The guide also details the program’s basic functions, operating modes, application management, image zone handling, I/O configuration, and procedures for updating sensor firmware. It concludes with instructions for disconnecting and closing the program safely.

What's inside

• Preliminary note
• Safety instructions
• System requirements
• Installation
• Basic functions of the program
• Operating modes
• Application management
• IO configuration
• Update sensor software
• Exit the program

Specifications

Frequently asked questions

How can I start the PC operating program directly from the CD without installing it?

Insert the CD, open the start menu and select the menu item "Start efector pmd3d" to launch the program.

How do I set a fixed IP address for the PC to communicate with the sensor?

Open the Internet protocol (TCP/IP) Properties, choose "Use the following IP address", enter the desired IP (e.g., 192.168.0.10) and subnet mask (255.255.255.0), leave the gateway blank, and confirm with OK.

What is required to update the sensor firmware?

Save the *.swu update file, connect to the sensor, select "Update sensor firmware" from the Applications menu, confirm the warning, and wait for the transmission to complete.

How can I disconnect the sensor from the PC program?

Choose "Disconnect" from the Connections menu or click the disconnect symbol in the toolbar, then confirm the query.