This manual introduces the operating method of Fuji digital display regulator.
The document begins with safety notices, emphasizing proper wiring, fuse installation, and protection against electric shock. It then describes the controller’s environmental limits, mounting methods, and sealing requirements for IP66 protection.
Subsequent sections cover detailed wiring diagrams, parameter settings, alarm configuration, automatic tuning, slope‑hold functions, digital inputs, and communication via Modbus RTU. Technical specifications, accessory lists, and troubleshooting tips are also included. This manual is written in Chinese.
| Power supply voltage | AC100‑240V 50/60Hz |
|---|---|
| Power consumption | 10VA (AC100V), 12VA (AC220V/AC‑DC24V) |
| Relay contact output | AC220V/DC30V, 3A (resistive load) |
| SSR/SSC driver output (ON state) | DC24V (DC17‑25V) |
| SSR/SSC driver output (OFF state) | <0.5V |
| Communication speed (RS‑485) | 9600 bps |
Mount the controller with the supplied sealing gasket and ensure no gaps between the gasket, the controller housing, and the panel as shown in the installation figures.
Set the AT parameter to “1” or “2” and press the SEL key; the small decimal point will flash to indicate tuning is in progress.
The controller operates from AC100‑240V, 50/60 Hz, with a power consumption of up to 10 VA at 100 V.