Thermo Fisher Scientific DT80 Error E30: Analog measurement fault

DT80 data logger · taken from the manufacturer’s manual, pages cited

Error codeE30

Analog measurement fault occurs due to a faulty circuit board, connector, or power supply. The manual lists no action for this code.

Model
Thermo Fisher Scientific DT80
Display shows
Analog measurement fault (E30)
Type
Error code
Source
Manual p. 402

What E30 means

Analog measurement fault p. 402

Common causes

  • Faulty circuit board, circuit board connector, or circuit board power supply p. 402

If E30 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Thermo Fisher Scientific service.

Open the manual at page 402 All DT80 error codes Manual details & download

This page summarises what the manufacturer’s manual says about E30; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Thermo Fisher Scientific. Found a mistake? Report an error.