Thermo Fisher Scientific DT80 Error E18: STATUS command error

DT80 data logger · taken from the manufacturer’s manual, pages cited

Error codeE18

STATUS command error occurs when the STATUsn value is outside the 1 to 14 range. The manual lists no action for this code.

Model
Thermo Fisher Scientific DT80
Display shows
STATUS command error (E18)
Type
Error code
Source
Manual p. 402

What E18 means

STATUS command error p. 402

Common causes

  • STATUsn outside the range 1 to 14 p. 402

If E18 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Thermo Fisher Scientific service.

Open the manual at page 402 All DT80 error codes Manual details & download

This page summarises what the manufacturer’s manual says about E18; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Thermo Fisher Scientific. Found a mistake? Report an error.