Error codeEr3
During zero clear operation, pressure was applied outside ±10%F.S., causing a residual pressure error that resets after three seconds. The manual's first action is: “Perform zero-clear operation again after restoring the applied pressure to an atmospheric pressure condition.”
- Model
- SMC ISE35 TFJ33GB-A
- Display shows
- Residual Pressure Error (Er3)
- Type
- Error code
- Source
- Manual p. 4
What Er3 means
Residual Pressure Error p. 4
Common causes
- During zero clear operation, pressure over ±10%F.S. is applied. In three seconds, the mode will reset to the measurement mode. ±Digits of the zero clear range is possible with product variations. p. 4
What to do
- Perform zero-clear operation again after restoring the applied pressure to an atmospheric pressure condition. p. 4
Before you service the product, read the safety instructions in the manual p. 1.
If Er3 is still not resolved
- contact service or dealer p. 1 “Pleasecheck thatyoufullyunderstand thedefin ition ofthefollowing messages(signs)before going ontoreadthetext,andalways followtheinstructions.”
This page summarises what the manufacturer’s manual says about Er3; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with SMC. Found a mistake? Report an error.