Siemens S5-115U Error 01: Start identifier (DB1) or end ident. (END) missing

Siemens S5-115U Programmable Controller · taken from the manufacturer’s manual, pages cited

Error code01

The start identifier (DB1) or end identifier (END) is missing in the program logic for the Siemens S5-115U. The manual lists no action for this code.

Model: Siemens S5-115U
Display shows: Start identifier (DB1) or end ident. (END) missing (01)
Type: Error code
Source: Manual p. 424

Meaning
Common causes
Still not solved
Source

What 01 means

Start identifier (DB1) or end ident. (END) missing p. 424

Common causes

Start identifier (DB1) or end ident. (END) missing p. 424

If 01 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Siemens service.

Open the manual at page 424 All S5-115U error codes Manual details & download

This page summarises what the manufacturer’s manual says about 01; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Siemens. Found a mistake? Report an error.