Siemens G120C Error 9007: Motor overload (8)

Siemens G120C drive · taken from the manufacturer’s manual, pages cited

Fault code9007

The motor was operated outside permissible limits, such as temperature, current, or torque, on the Siemens G120C drive. The manual's first action is: “Check the load cycles and set limits. Check the ambient temperature / motor cooling.”

Model
Siemens G120C
Display shows
Motor overload (8) (9007)
Type
Fault code
Source
Manual p. 654

What 9007 means

Motor overload (8) p. 654

Common causes

  • The motor was operated outside the permissible limits (temperature, current, torque ...). p. 654

What to do

  1. Check the load cycles and set limits. Check the ambient temperature / motor cooling. p. 654

Before you service the product, read the safety instructions in the manual p. 4.

If 9007 is still not resolved

  • contact service / dealer p. 4
    “Warning concept This Manual contains information which you must observe to ensure your own personal safety as well as to avoid material damage.”
  • contact service / dealer p. 12
    “WARNING Danger to life if the safety instructions and residual risks are not observed”
Open the manual at page 654 All G120C error codes Manual details & download

This page summarises what the manufacturer’s manual says about 9007; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Siemens. Found a mistake? Report an error.