One of the following conditions applies: Correction data has been switched off. No correction values are available, for example after a firmware update. Record the correction data by performing a self The manual's first action is: “(For details refer to chapter 3.1.1.6, "Performing a Self-Alignment and a Self-test", on page 26).”
- Model
- Rohde & Schwarz FSW
- Display shows
- UNCAL
- Type
- Error code
- Source
- Manual p. 82
What UNCAL means
One of the following conditions applies: Correction data has been switched off. No correction values are available, for example after a firmware update. Record the correction data by performing a self alignment. p. 82
Common causes
- One of the following conditions applies: Correction data has been switched off. No correction values are available, for example after a firmware update. Record the correction data by performing a self alignment. p. 82
What to do
- (For details refer to chapter 3.1.1.6, "Performing a Self-Alignment and a Self-test", on page 26). p. 82
If UNCAL is still not resolved
The manual gives no further instruction for this code. Open the code table in the PDF or contact Rohde & Schwarz service.
This page summarises what the manufacturer’s manual says about UNCAL; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Rohde & Schwarz. Found a mistake? Report an error.