Rohde & Schwarz FSW Error 2028: Hardcopy not possible during measurement sequence

Signal and spectrum analyzer · taken from the manufacturer’s manual, pages cited

Error code2028

Hardcopy not possible during measurement sequence The manual's first action is: “In such cases synchronization to the end of the scan sequence should be performed prior to starting the printout.”

Model
Rohde & Schwarz FSW
Display shows
Hardcopy not possible during measurement sequence (2028)
Type
Error code
Source
Manual p. 1102

What 2028 means

Hardcopy not possible during measurement sequence p. 1102

Common causes

  • A printout is started during scan sequences that cannot be interrupted. Such sequences are for example: Recording the system error correction data (alignment) Instrument self test. p. 1102

What to do

  1. In such cases synchronization to the end of the scan sequence should be performed prior to starting the printout. p. 1102

If 2028 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Rohde & Schwarz service.

Open the manual at page 1102 All FSW error codes Manual details & download

This page summarises what the manufacturer’s manual says about 2028; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Rohde & Schwarz. Found a mistake? Report an error.