Rockwell Automation PowerFlex 400 FRN 4.xx Error F63: SW OverCurrent(1)

PowerFlex 400 FRN 4.xx · taken from the manufacturer’s manual, pages cited

Fault codeF63

SW OverCurrent(1) occurs when load requirements exceed the SW Current Trip setting (A098). The manual lists no action for this code.

Model
Rockwell Automation PowerFlex 400 FRN 4.xx
Display shows
SW OverCurrent(1) (F63)
Type
Fault code
Source
Manual p. 25

What F63 means

SW OverCurrent(1) p. 25

Common causes

  • Check load requirements and A098 [SW Current Trip] setting. p. 25

If F63 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Rockwell Automation service.

Open the manual at page 25 All PowerFlex 400 FRN 4.xx error codes Manual details & download

This page summarises what the manufacturer’s manual says about F63; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Rockwell Automation. Found a mistake? Report an error.