Rockwell Automation MicroLogix 1400 Error E7H: Target node cannot respond because the length requested is too large.

MicroLogix 1400 Programmable Controller · taken from the manufacturer’s manual, pages cited

Error codeE7H

Target node cannot respond because the length requested is too large. The manual lists no action for this code.

Model
Rockwell Automation MicroLogix 1400
Display shows
E7H
Type
Error code
Source
Manual p. 311

What E7H means

Target node cannot respond because the length requested is too large. p. 311

Common causes

  • Target node cannot respond because the length requested is too large. p. 311

If E7H is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Rockwell Automation service.

This page summarises what the manufacturer’s manual says about E7H; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Rockwell Automation. Found a mistake? Report an error.