Rockwell Automation MicroLogix 1400 Error C0H

MicroLogix 1400 Programmable Controller · taken from the manufacturer’s manual, pages cited

Error codeC0H

No IP address configured for the network, or Bad command - unsolicited message error, or Bad address - unsolicited message error, or No privilege - unsolicited message error, or Multihop messaging can indicates a networking configuration issue or invalid request received without proper authorization. The manual lists no action for this code.

Model
Rockwell Automation MicroLogix 1400
Display shows
C0H
Type
Error code
Source
Manual p. 310

What C0H means

No IP address configured for the network, or Bad command - unsolicited message error, or Bad address - unsolicited message error, or No privilege - unsolicited message error, or Multihop messaging cannot route request. p. 310

Common causes

  • No IP address configured for the network, or Bad command - unsolicited message error, or Bad address - unsolicited message error, or No privilege - unsolicited message error, or Multihop messaging cannot route request. p. 310

If C0H is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Rockwell Automation service.

This page summarises what the manufacturer’s manual says about C0H; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Rockwell Automation. Found a mistake? Report an error.