Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
F7 means an error occurred while setting an A/B slave, specifically when writing a standard slave address like 01 or 02 to an A/B slave. The manual lists no action for this code.
F6 indicates an error occurred while setting a standard slave, such as attempting to write an A/B slave address like 01A or 01B to a standard slave. The manual lists no action for this code.
F5 means an error occurred during a settings change, specifically when a slave with address 0 is connected. The manual lists no action for this code.
F4 indicates an error occurred during an address setting, such as attempting to write a duplicated address. The manual lists no action for this code.
F3 signifies an error occurred while writing the address or ID code 1. The manual lists no action for this code.
F2 means the slave is disconnected, not connected properly, or there was a failure in reading the slave. The manual lists no action for this code.
F1 indicates an overloading or short-circuiting of the communications power supply provided from the unit. The manual lists no action for this code.
All 8 error codes of the Fuji Electric TWIN series TWIN series MCCB/ELCB with their meaning, causes and what to do, taken from the manufacturer's manual with page references.
No response was received to the poll message sent to the device. The manual lists no action for this code.
The local memory address provided in the command is invalid as the location does not exist or is uninitialised. The manual lists no action for this code.
The Modbus TCP server could not be connected because it is offline. The manual lists no action for this code.
The command type or slave address did not match the request, likely indicating another unit is involved. The manual lists no action for this code.
No response was received from the target device, typically because it is not present on the network. The manual lists no action for this code.
The gateway was unable to allocate an internal communication path for the request due to network constraints. The manual lists no action for this code.
An extended file area failed consistency check during memory operations, indicating a parity error. The manual lists no action for this code.