Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
Feelers are positioned outside measurable range during front surface measurement. The manual lists no action for this code.
Feelers are positioned outside measurable range during rear surface measurement. The manual lists no action for this code.
Startpoint and endpoint measurement data for lens shape do not match. The manual's first action is: “Measure the lens shape again with the button.”
First lens shape measurement data is abnormal. The manual lists no action for this code.
Lens measurement data or result is abnormal. The manual's first action is: “Restart operation from frame tracing.”
Front surface cannot be measured after rear surface has been measured. The manual's first action is: “Lightly press the feelers during front surface measurement.”
Feelers have not been initialized for measurement. The manual's first action is: “Move the feelers to the center of the processing chamber by lifting it up. Press the button. When the feelers cannot be moved due to th…
Wheel fails to rotate at the start of processing. The manual's first action is: “Turn off the power and then turn it on again after 20 seconds or more.”
Roughing process has not been completed successfully. The manual lists no action for this code.
Error occurs when received data in VCA communication is not compliant. The manual's first action is: “Confirm whether or not the received processing information is proper.”
Error occurs when data reception during processing fails. The manual's first action is: “Check connection with the cable(s) from the RS-232C port(s) or periphery instrument(s).”
Error occurs when data transmission during processing fails. The manual's first action is: “Check connection of the cable(s) from the RS-232C port(s) or periphery instrument(s).”
All 14 error codes of the NIDEK Le 1000 patternless edger with their meaning, causes and what to do, taken from the manufacturer's manual with page references.
Bipolars indicates that received pulses are deformed and cannot be properly interpreted as T1 signals. The manual's first action is: “1. Verify cable from CSU to ECS meets specs and all connections are good.”
Transmit Signal Loss means the ECS has stopped sending signals to the network or far end, and a yellow alarm is returned on the receive pair. The manual's first action is: “1. Do loopback from CSU to Smart Jack.”