Error codeE013
The speed contouring error limit has been reached. The manual's first action is: “Set a higher value in P327.”
- Model
- NORDAC SK 500E / SK 520E
- Display shows
- Speed contouring error (E013)
- Type
- Error code
- Source
- Manual p. 17
What E013 means
Speed contouring error p. 17
Common causes
- Contouring error limit was reached. p. 17
What to do
- Set a higher value in P327. p. 17
If E013 is still not resolved
The manual gives no further instruction for this code. Open the code table in the PDF or contact NORDAC service.
This page summarises what the manufacturer’s manual says about E013; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with NORDAC. Found a mistake? Report an error.