Mitsubishi Electric FX5 Error 1A0DH: Averaging process specification setting range error

PLC · taken from the manufacturer’s manual, pages cited

Error code1A0DH

A value other than 0 to 3 was set in CH□ Averaging process specification. The manual's first action is: “Reset CH□ the Averaging process specification to 0 to 3.”

Model
Mitsubishi Electric FX5
Display shows
Averaging process specification setting range error (1A0DH)
Type
Error code
Source
Manual p. 62

What 1A0DH means

Averaging process specification setting range error p. 62

Common causes

  • A value other than 0 to 3 was set in CH□ Averaging process specification. p. 62

What to do

  1. Reset CH□ the Averaging process specification to 0 to 3. p. 62

Before you service the product, read the safety instructions in the manual p. 3.

If 1A0DH is still not resolved

  • contact service / dealer p. 3
    “It is important to follow all precautions for personal safety.”
  • contact service / dealer p. 4
    “Failure to do so may cause electric shock or damage to the product.”
Open the manual at page 62 All FX5 error codes Manual details & download

This page summarises what the manufacturer’s manual says about 1A0DH; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Mitsubishi Electric. Found a mistake? Report an error.