Mitsubishi Electric 600M Series Error SV0030: Over regeneration

CNC milling machine · taken from the manufacturer’s manual, pages cited

Error codeSV0030

Over regeneration indicates overheating of the regenerative resistor was detected. The manual lists no action for this code.

Model
Mitsubishi Electric 600M Series
Display shows
Over regeneration (SV0030)
Type
Error code
Source
Manual p. 468

What SV0030 means

Over regeneration p. 468

Common causes

  • Overheating of the regenerative resistor was detected. p. 468

If SV0030 is still not resolved

  • contact service / dealer p. 5
    “Do not change the fixed cycle program without prior consent from the machine manufacturer.”
  • contact service / dealer p. 5
    “Do not turn OFF the NC a”
Open the manual at page 468 All 600M Series error codes Manual details & download

This page summarises what the manufacturer’s manual says about SV0030; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Mitsubishi Electric. Found a mistake? Report an error.