Mitsubishi Electric 600M Series Error PR0607: Signal turned illegally with G37

CNC milling machine · taken from the manufacturer’s manual, pages cited

Error codePR0607

A signal was turned on or off illegally during a D-commanded deceleration area. The manual's first action is: “Reconsider the program.”

Model
Mitsubishi Electric 600M Series
Display shows
Signal turned illegally with G37 (PR0607)
Type
Error code
Source
Manual p. 488

What PR0607 means

Signal turned illegally with G37 p. 488

Common causes

  • Before the area commanded by the D command or the parameter deceleration area D, the measure-ment position arrival signal went ON, or resulted in not going ON. p. 488

What to do

  1. Reconsider the program. p. 488

Before you service the product, read the safety instructions in the manual p. 4.

If PR0607 is still not resolved

  • contact service / dealer p. 5
    “Do not change the fixed cycle program without prior consent from the machine manufacturer.”
  • contact service / dealer p. 5
    “Do not turn OFF the NC a”
Open the manual at page 488 All 600M Series error codes Manual details & download

This page summarises what the manufacturer’s manual says about PR0607; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Mitsubishi Electric. Found a mistake? Report an error.