Mitek VAPR II / VAPR 3 Error 300: Internal overheating (refer to Troubleshooting Guide)

Electrosurgical device · taken from the manufacturer’s manual, pages cited

Fault code300

Error 300 signifies internal overheating or out-of-specification input voltage (low or high). The manual's first action is: “Refer to Troubleshooting Guide.”

Model
Mitek VAPR II / VAPR 3
Display shows
Internal overheating (refer to Troubleshooting Guide) (300)
Type
Fault code
Source
Manual p. 35

What 300 means

Internal overheating (refer to Troubleshooting Guide) p. 35

Common causes

  • Internal overheating p. 35
  • Out of specification input voltage : low p. 35
  • Out of specification input voltage : high p. 35
  • Accessory Fault p. 35
  • Temperature control system problem p. 35
  • Unsupported electrode p. 35

What to do

  1. Refer to Troubleshooting Guide. p. 35
  2. Refer to Trouble Shooting Guide. p. 35

Before you service the product, read the safety instructions in the manual p. 10.

If 300 is still not resolved

  • Contact Mitek technical service for assistance. p. 10
    “Contact Mitek technical service for assistance.”
Open the manual at page 35 All VAPR II / VAPR 3 error codes Manual details & download

This page summarises what the manufacturer’s manual says about 300; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Mitek. Found a mistake? Report an error.