Jenco 1671 Error ERR-3: Measurement temperature greater than 100.0 or less than 0.0

Jenco 1671 · taken from the manufacturer’s manual, pages cited

Error codeERR-3

The system detected a temperature measurement outside the acceptable range of 0.0 to 100.0. The manual's first action is: “Correct the error and measure pH again. Possible temperature sensor failure.”

Model
Jenco 1671
Display shows
Measurement temperature greater than 100.0 or less than 0.0 (ERR-3)
Type
Error code
Source
Manual p. 14

What ERR-3 means

Measurement temperature greater than 100.0 or less than 0.0 p. 14

Common causes

  • Measurement temperature greater than 100.0 or less than 0.0 p. 14

What to do

  1. Correct the error and measure pH again. Possible temperature sensor failure. p. 14

If ERR-3 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Jenco service.

Open the manual at page 14 All 1671 error codes Manual details & download

This page summarises what the manufacturer’s manual says about ERR-3; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Jenco. Found a mistake? Report an error.