Jenco 1671 Error ERR-1: Cannot calibrate pH 7.00 with this setup

Jenco 1671 · taken from the manufacturer’s manual, pages cited

Error codeERR-1

Cannot calibrate pH 7.00 with this setup The manual's first action is: “check buffer solution, electrode, cable, connectors.”

Model
Jenco 1671
Display shows
Cannot calibrate pH 7.00 with this setup (ERR-1)
Type
Error code
Source
Manual p. 14

What ERR-1 means

Cannot calibrate pH 7.00 with this setup p. 14

Common causes

  • Cannot calibrate pH 7.00 with this setup p. 14

What to do

  1. check buffer solution, electrode, cable, connectors. p. 14

If ERR-1 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Jenco service.

Open the manual at page 14 All 1671 error codes Manual details & download

This page summarises what the manufacturer’s manual says about ERR-1; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Jenco. Found a mistake? Report an error.