HMS HMS1310 Error Codes

34 codes from pages 361–365 of the manual

This is the list of error codes the HMS manual gives for the HMS1310 sewing machine. Find your code below and open it for what the manual says about its causes and what to do.

Error codes from p. 361

CodeWhat it meansPage
E001 Pedal is not at the middle position. p. 361
E002 Machine is in emergency stop p. 361
E004 Main voltage is too low(300V) p. 361
E005 Main voltage is too high(300V) p. 361
E007 IPM is over-voltage or over-current p. 361
E008 Voltage of assistant device(24V) is too high p. 361
E009 Voltage of assistant device(24V) is too low p. 361
E010 Valve short connection or fan blocks p. 361
E013 Encoder is error or unconnected. p. 361
E014 Motor running abnormal p. 361
E015 Exceeds sewing area p. 361
E016 Needle bar upper position abnormal p. 361
E017 Thread breakage detection error p. 361
E018 Knife position abnormal p. 361
E019 Emergency switch is not at the right position p. 361
E020 Stepping version error p. 361
E023 Thread-catching position abnormal p. 361
E024 Wrong connection between operation panel and sewing machine p. 361
E025 X origin detection abnormal p. 361
E026 Y origin detection abnormal p. 361
E027 Presser origin detection abnormal p. 361
E028 Thread-catching origin detection abnormal p. 361
E029 Intermediate presser origin detection abnormal p. 361
E030 Stepping driver communication abnormal p. 361
E031 Stepping motor over-current p. 361
E032 Stepping driver power supply abnormal p. 361
E034 Abnormal current p. 361
E035 IPM over-current 1 p. 361
E036 IPM over-current 2 p. 361
E037 Motor blockage 1 p. 361
E038 Motor blockage 2 p. 361
E039 Motor over speed p. 361
E040 Over-current at stop p. 361
E041 Motor overload p. 361

Codes and descriptions are taken from the manufacturer’s manual; page numbers link to the PDF. ManualLib is not affiliated with HMS. Found a mistake? Report an error.