GSK GSK980TB3 Error 100: Parameter switch is ON

GSK GSK980TB3 · taken from the manufacturer’s manual, pages cited

Alarm code100

The parameter switch is turned ON. The manual's first action is: “Set parameter switch to the state of “OFF” (In MDI mode, press character “W” on the setting page), or press reset key.”

Model
GSK GSK980TB3
Display shows
Parameter switch is ON (100)
Type
Alarm code
Source
Manual p. 268

What 100 means

Parameter switch is ON p. 268

Common causes

  • Parameter switch is ON. p. 268

What to do

  1. Set parameter switch to the state of “OFF” (In MDI mode, press character “W” on the setting page), or press reset key. p. 268

If 100 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact GSK service.

Open the manual at page 268 All GSK980TB3 error codes Manual details & download

This page summarises what the manufacturer’s manual says about 100; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with GSK. Found a mistake? Report an error.