Alarm code038
Excessive cutting occurs when circular arc start or end point matches center point during tool nose radius compensation. The manual's first action is: “Modify the program”
- Model
- GSK GSK980TB3
- Display shows
- 038
- Type
- Alarm code
- Source
- Manual p. 265
What 038 means
In tool nose radius compensation, excessive cutting occurs as starting point or terminal point of the circular arc coincides with the center point, p. 265
Common causes
- In tool nose radius compensation, excessive cutting occurs as starting point or terminal point of the circular arc coincides with the center point, p. 265
- In tool nose radius compensation, excessive cutting occurs as starting point or terminal point of the circular arc coincides with the center point. p. 265
What to do
- Modify the program p. 265
If 038 is still not resolved
The manual gives no further instruction for this code. Open the code table in the PDF or contact GSK service.
This page summarises what the manufacturer’s manual says about 038; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with GSK. Found a mistake? Report an error.