Switch Error F10 occurs when a remote test, calibrate, or magnetic switch remains closed longer than two minutes. The manual's first action is: “Check the wiring on the remote reset and remote calibrate switches. Once the short circuit is cleared, the unit will return to normal operation. If the magnetic switch is shorted, the unit must be returned to the factory or to an authorized service center for service.”
- Model
- General Monitors S4000TH
- Display shows
- Switch Error (F10)
- Type
- Error code
- Source
- Manual p. 40
What F10 means
Switch Error p. 40
Common causes
- This fault occurs if either the "remote test," "remote calibrate," or magnetic switch is closed for more than two minutes. p. 40
What to do
- Check the wiring on the remote reset and remote calibrate switches. Once the short circuit is cleared, the unit will return to normal operation. If the magnetic switch is shorted, the unit must be returned to the factory or to an authorized service center for service. p. 40
If F10 is still not resolved
The manual gives no further instruction for this code. Open the code table in the PDF or contact General Monitors service.
This page summarises what the manufacturer’s manual says about F10; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with General Monitors. Found a mistake? Report an error.