Gefran ARTDriveL Error 9052: OV restart

Gefran ARTDriveL drive · taken from the manufacturer’s manual, pages cited

Fault code9052

The drive restarts due to DC link voltage exceeding the maximum threshold set for mains voltage. The manual's first action is: “Overvoltage restart”

Model
Gefran ARTDriveL
Display shows
OV restart (9052)
Type
Fault code
Source
Manual p. 183

What 9052 means

OV restart p. 183

Common causes

  • It trips when the voltage on the drive DC link is higher than the maximum threshold according to the Mains voltage setting p. 183

What to do

  1. Overvoltage restart p. 183

If 9052 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Gefran service.

Open the manual at page 183 All ARTDriveL error codes Manual details & download

This page summarises what the manufacturer’s manual says about 9052; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Gefran. Found a mistake? Report an error.