Gefran ARTDriveL Error 28: UT repetitive

Gefran ARTDriveL drive · taken from the manufacturer’s manual, pages cited

Fault code28

The inverter has detected a repetitive external fault input signal. The manual's first action is: “Programmable”

Model
Gefran ARTDriveL
Display shows
UT repetitive (28)
Type
Fault code
Source
Manual p. 190

What 28 means

UT repetitive p. 208

Common causes

  • External fault input is active p. 208

What to do

  1. Programmable p. 208

If 28 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Gefran service.

Open the manual at page 190 All ARTDriveL error codes Manual details & download

This page summarises what the manufacturer’s manual says about 28; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Gefran. Found a mistake? Report an error.