GE Fuji AF-300 Mini™ Error Er6: Operation protection

GE Fuji AF-300 Mini Drive · taken from the manufacturer’s manual, pages cited

Error codeEr6

Operation protection activated when key was pressed with H66 set to 1 or 3, or start check function activated with H66 set to 2 or 3. The manual's first action is: “CHECK Change the setting for H66 so that the STOP key priority function is invalid to ensure that the drive does not operate unexpectedly.”

Model
GE Fuji AF-300 Mini™
Display shows
Operation protection (Er6)
Type
Error code
Source
Manual p. 79

What Er6 means

Operation protection p. 93

Common causes

  • The key was pressed when H66 = 1 or 3. p. 93
  • The start check function was activated when H66 = 2 or 3. p. 93

What to do

  1. CHECK Change the setting for H66 so that the STOP key priority function is invalid to ensure that the drive does not operate unexpectedly. p. 93
  2. CHECK Check that Er6 occurs when: – The power is switched ON. – An alarm is released (the key is pressed) – The link command (LE) has switched the drive operations. SUGGESTED ACTIONS – Reconsider the running sequence to avoid input of the run command when Er6 has occurred. – Change the setting for H66 so that the STOP key priority function is invalid to ensure the drive does not operate unexpectedly. (To reset the alarm, turn the run command off.) p. 93

Before you service the product, read the safety instructions in the manual p. 4.

If Er6 is still not resolved

  • Contact a qualified electrician for wiring p. 5
    “Wiring must only be performed only by a qualified electrician.”
  • Check that power is off before wiring p. 24
    “Check that the power is turned off before proceeding with any wiring Failure to do so may result in electric shock.”
Open the manual at page 79 All AF-300 Mini™ error codes Manual details & download

This page summarises what the manufacturer’s manual says about Er6; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with GE Fuji. Found a mistake? Report an error.