GE Fuji AF-300 Mini™ Error E-6: Operation Protection

GE Fuji AF-300 Mini Drive · taken from the manufacturer’s manual, pages cited

Alarm codeE-6

The drive has stopped because the STOP key was pressed, overriding any run commands from terminals or communications. The manual's first action is: “Pressing key on the keypad forces the motor to decelerate and stop even if the drive is running by any run commands given via the terminals or communications (link operation). After the motor stops, the drive issues an alarm "Er6".”

Model
GE Fuji AF-300 Mini™
Display shows
Operation Protection (E-6)
Type
Alarm code
Source
Manual p. 117

What E-6 means

Operation Protection p. 117

Common causes

What to do

  1. Pressing key on the keypad forces the motor to decelerate and stop even if the drive is running by any run commands given via the terminals or communications (link operation). After the motor stops, the drive issues an alarm "Er6". p. 117
  2. Any run operations are prohibited, and the drive displays "Er6" on the LED display if any run command is given when: - Powering up - Releasing an alarm (key turned ON) - Link command (LE) has switched drive operations p. 117

Before you service the product, read the safety instructions in the manual p. 4.

If E-6 is still not resolved

  • Contact a qualified electrician for wiring p. 5
    “Wiring must only be performed only by a qualified electrician.”
  • Check that power is off before wiring p. 24
    “Check that the power is turned off before proceeding with any wiring Failure to do so may result in electric shock.”
Open the manual at page 117 All AF-300 Mini™ error codes Manual details & download

This page summarises what the manufacturer’s manual says about E-6; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with GE Fuji. Found a mistake? Report an error.