Fujitsu fi-7300NX Error H0: Motor circuit error

Image scanner · taken from the manufacturer’s manual, pages cited

Error codeH0

Motor circuit error is displayed when there is an issue with the motor circuit of the scanner. The manual's first action is: “Turn the scanner off then back on.”

Model
Fujitsu fi-7300NX
Display shows
Motor circuit error (H0)
Type
Error code
Source
Manual p. 143

What H0 means

Motor circuit error p. 152

What to do

  1. Turn the scanner off then back on. p. 152
  2. If the problem persists, write down the error code and contact the distributor/dealer where you purchased this product. Or, make an inquiry by referring to the contact information at the Contact for Inquiries section in Safety Precautions bundled with this product. p. 152

Before you service the product, read the safety instructions in the manual p. 140.

If H0 is still not resolved

  • contact service or dealer p. 108
    “For details, refer to How to Open the ADF (page 62) .”
  • contact service or dealer p. 110
    “For details, refer to How to Open the ADF (page 62) .”
Open the manual at page 143 All fi-7300NX error codes Manual details & download

This page summarises what the manufacturer’s manual says about H0; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Fujitsu. Found a mistake? Report an error.